Closing Time. This pool won't be open 'til sun or heat come

Sadly, it’s that time again. The temperature is beginning to drop and it’s time to close your pool for the season. If you couldn’t make it to our pool school, we’ve got you covered. The winter ❄️ can be really brutal in upstate NY thats why it is important not to miss a single thing when closing a pool. Here are a few major things Tarson Pools service team takes care of to ensure you get the most out of your pool for the years to come ☀️!

1) Vacuum and Test 💨 

The cleaner your pool is when it’s closed, the cleaner it will be when it reopens. Leaving debris and leaves in your pool increases the risk of staining and results in a higher demand for chemicals, so be thorough. Check your water chemistry to ensure it is balanced. We can do it for free here at Tarson in 5 minutes. Doing this will optimize your water balance and make sure you are getting the full potential out of your chemicals.

*If your water is green or discolored, address this before closing your pool.

2) Add Winter Chemicals 🧪
Once the water is tested and balanced, add your winter chemicals as directed. In most cases, the pump should be on. DO NOT add  the chemicals into the skimmer. Allow the chemicals to circulate for 2-4 hours before continuing the process.

3) Remove Hardware 🔧
Remove all ladders, toys, diving boards, etc. Reduce wear by placing them in a dry, safe environment so you can enjoy them next season.

4) Drop the Water Level
Change the valve in front of your pump to select the Port 2 setting (the main suction line) and then set your filter to the drain (waste) position. Drain the pool water level 2-4 inches below the bottom of the skimmer.

* If you choose not to drain the pool water level, use a Blowout Extension. It allows you to reduce the force taken by the skimmer when the water freezes.

5) Filtration and Circulation Removal 🔁
Disconnect the filter, pump and heater from their lines and pull the plugs so they can drain. Store the pump indoors and use a Pump Protector to prevent seals from going bad. DO NOT place the sand filter indoors. The sand filter often weight hundreds of pounds. If the sand in the filter shifts  it could result in the internals of the filter breaking. DE filters should be cleaned and acid washed before being stored indoors.

6) Blow Out Lines
Select the Port 1 section on the valve to blow out the skimmer line. Using a blower or shop-vac, blow into the valve to push all of the water out of the skimmer lines and return lines. The air will come out of the closest return line first, so plug the line with a 1.5” winter plug then move on to the next. Now that all of the lines are blown out, add nontoxic antifreeze. Use a minimum of 1/2 gallon for every line. For the main drain, which cannot be blown out, use a full gallon of antifreeze.

Blowing out pool inground lines tarson pools pool closing7) Cover Pool
Place the cover over your pool so that it comfortably fits flat on the water. You don’t want your cover to be tight or strained because this may lead to tearing. Place the water bags inside of the designated straps (on inground pools)  to weigh down the cover. Fill the water bags half way to leave room for expansion. Place them end to end to avoid wind moving the cover. For extra weight, spray an inch or two of water on the cover.